top of page


Public·161 membres

Vag K Can Commander Software ((INSTALL)) Free 35

Download File --->>>

How to Download and Install VAG K+CAN Commander Software for Free

VAG K+CAN Commander is a diagnostic tool that allows you to read and write data from various control units of VAG group cars, such as Volkswagen, Audi, Seat, Skoda, and Porsche. You can also use it to correct odometer readings, read security codes, program keys, reset airbag errors, and more. In this article, we will show you how to download and install VAG K+CAN Commander software for free.

Step 1: Download the software

There are different versions of VAG K+CAN Commander software available online, such as 1.4, 3.6, 5.1, and 5.5. You can choose the one that suits your needs and your device. Here are some links where you can download the software for free:

Vag k line + can commander 1.4, 3.6, 5.1,5.5 software Download

VAG K+Can Commander 3.6 Full

SE62 VAG K+CAN Commander Full 1.4

360diag software download center-Auto diagnostic tools-Download / VAG ...

After downloading the software, you need to unzip it to a folder on your computer.

Step 2: Install the USB drivers

To connect your VAG K+CAN Commander device to your computer, you need to install the USB drivers that are included in the software package. Follow these steps:

Plug your device into your computer's USB port.

Open the folder where you unzipped the software and find the folder named "USB_Driver".

Run the file named "Install.exe" and follow the instructions on the screen.

Restart your computer after the installation is complete.

Step 3: Verify the port settings

To communicate with your device, you need to make sure that the port settings are correct. Follow these steps:

Open the Control Panel on your computer and go to Device Manager.

Find the device named "USB Serial Port" under the "Ports (COM & LPT)" section.

Right-click on it and select "Properties".

Go to the "Port Settings" tab and check that the baud rate is set to 9600 and the parity is set to none.

Click "OK" to save the settings.

Step 4: Run the VAG K+CAN Commander software

Now you are ready to run the VAG K+CAN Commander software and start diagnosing your car. Follow these steps:

Open the folder where you unzipped the software and find the file named "Vag_K_CAN_Commander.exe".

Double-click on it to launch the software.

Select the correct COM port from the drop-down menu at the top left corner of the software window.

Select the protocol (K-line or CAN) and click "Connect".

Select the control unit you want to access from the list on the left side of the software window.

Perform the desired functions such as reading data, writing data, coding, adaptation, etc. a474f39169

À propos

Bienvenue dans le groupe ! Vous pouvez communiquer avec d'au...


bottom of page